sensor

  1. JAC

    Engine caption advice

    Hi all, my 01 2.2 had an orange engine caption which was reset at a recent MOT. The mechanic couldn’t see a fault and suggested it may have been from a cold weather start or a dodgey sensor (which he offered to disconnect). The caption has come on again however there is still no obvious fault...
  2. colb

    Cam Sensor Code 1.9 M43

    Zedshed Cymru in action this morning for Julians 1.9 M43, EML lit up on him in the week, put BMW Scanner on it to reveal a Camshaft Sensor code. Cleared the code and ran the engine, code returned. No spare to hand so couldn't change it. Quick check over the engine also revealed a split in the...
  3. n_mistry

    Lambda Sensors

    Afternoon folks, I'm getting the check engine light, drives fine so figured its the O2 sensors. This was the case when I used to own an E46 330Ci. Same engine as my Z3 3.0 so guessing its same problem. Went to my usual garage to read code and comes up with "fuel trim range exceeded" on both...
  4. colb

    Double post for deletion

    Double post, Mods please delete
  5. colb

    AUC Sensor Error Code OF[015]

    Having sorted my new key out I turned my attention to the AUC Sensor Error code I keep getting, it relates to what is known as the 'stink sensor' that is mounted at the top of the radiator shroud. It senses polloutants in the outside air and closes the fresh air inlet vents and sets the inside...
  6. colb

    E46 Camshaft Sensors and lower intake boot

    Not on a Z but on my mates 2.5 Series 3 Coupe from 2001. Lumpy running juddering at low speed, bad tickover. Code reader on it revealed codes set for camshaft sensors inlet and exhaust. Car did not have a MIL light on. Replaced both camshaft sensors, also spotted that the lower intake hose had a...
  7. M

    Improving Acceleration and performance.

    I have a 2.8L 98 Z3 and I really feel i'm not getting the acceleration and power from the engine that I deserve. Was wondering is there anything I can do to bring it back to the original Acceleration specs or add power etc? Possibly changing a sensor of some description? Any advice greatly...
  8. ZedLeppelin

    HELP! Engine Management Light on and no power...

    Hi everyone, I have just had an engine management light come on and my car has either gone into limp home mode or has seen a massive loss of power (2.0litre 2006 z4, 67k miles). There is now no acceleration whatsoever but the car does start and allows me to drive it. Is it ok to drive still...
  9. Redline

    Another Emissions Indicator problem?!?

    On the way to work this morning I had the Emission Degradation Indicator come on. I didn't notice immediately and didn't even know what it was when I saw it. Nothing seemed to be amiss - all the power was there, no noise or other sign so after a quick inspection, I pressed on - my presumption...
Top