z3m

  1. Brendan Loghides

    HELP NO START ISSUE!

    Looking for some major help with my z3. I am unable to get the car started after swapping an s52 into the chassis as well as a manual swap. The car was a 1.9 auto before. I have gotten a new ecu, ews, key chip, and ews antenna for the ignition cylinder all matching wired up in the car. The car...
  2. MattM

    For Sale Posters of Z3 Roadster Artworks For Sale

    As a fellow member of this forum, I wanted to share this with you as am hoping they will be of interest. I have been the owner of a BMW Z3 for just over 4 years and a graphic designer for the last 25 years and I recently decided to combine my passion for both, to create the artwork for a set of...
  3. jamesholder247

    Hello Everyone

    Hi all, Long time reader and user of this forum and sure I had an account in the past but can't seem to find it. Anyway I am rubbish with computers, but not so bad at car DIY. I have a 99 Z3M in Cosmos Black which I have done the following on if anyone is interested since I have had it (About...
  4. Pete-BStoke

    Video Surface rust on sill, can it be trusted

    Hi everyone, I’ve owned 3 z3’s over the last 15 years, love them. I’m recently in a fortunate position to potentially purchase a Z3m roadster. It’s fairly well priced from a dealer for a 02 plate. Upon viewing I noticed rust on the outer sills, one in particular is heavily corroded. Other...
  5. BMWCCGB Cadwell Park 14th May 2018

    BMWCCGB Cadwell Park 14th May 2018

  6. BMWCCGB Cadwell Park 14th May 2018

    BMWCCGB Cadwell Park 14th May 2018

  7. BMWCCGB Cadwell Park 14th May 2018

    BMWCCGB Cadwell Park 14th May 2018

  8. BMWCCGB Cadwell Park 14th May 2018

    BMWCCGB Cadwell Park 14th May 2018

  9. BMWCCGB Cadwell Park 14th May 2018

    BMWCCGB Cadwell Park 14th May 2018

  10. BMWCCGB Cadwell Park 14th May 2018

    BMWCCGB Cadwell Park 14th May 2018

  11. fxslin

    Driving with 35mm spacers

    Got a question that I can't seem to find good answer on, hopefully somebody can share experience/opinions on this. I got some 18X9.5 rims with ET 43, so I sourced my self a pair H&R bolt on spacers ( H&R wheel spacer system DRA Silver Edition - 35mm - TUV approved ). With the spacers on the...
  12. pinkpiggy

    Wanted Z3 M battery box

    Hello guys, because of my plan is "rebuild" my trunk on my coupe on m trunk (because of exhaust), i would like to buy battery box. I am located in Czech republic (post is probably only solution). As well as battery box i would love to buy the toolbox as well (tools doesnt need to be included)...
  13. pinkpiggy

    Found Z3 M front bumper

    Hello guys, because of I am not able to find ac schnitzer front splitters for my z3, I am looking for M front bumper. Anyone has one for sale? I am located in middle europe (czech republic) so shipping is necessary in most cases. I can drive for that bumper in closer areas like east germany...
  14. Summit Detailing

    Difficult to get yellow to shine..got there in the end!

    Hello all, Just a couple of pics to show that given the right amount of time/attention/love Yellow can look sharp! This M Coupe was on the receiving end of a 3-day Detail to remove a decent amount of paint defects which were robbing the car of the sharp reflections, clarity and 'yellowness'...
  15. BatMobil

    BatMobil

Top